![]() Run the end of the rope that’s in your right hand behind the loop toward your horse’s eye, then punch it through the new loop you’ve just created.Hold the end of the rope that’s through the loophole in your right hand, and hold the loophole with your left thumb.Once you have the halter properly positioned on your horse’s head, pass the end of the rope around and behind your horse’s ears and pass it down through the loophole of the other end of the rope.Slide the halter onto your horse’s head the same way you would any other halter, following steps 1-5 above.| The Horse staffīecause rope halters don’t have any hardware, you’ll need to secure yours using a knot. How To Put a Rope Halter on a HorseĪ properly tied rope halter. The noseband should lie two fingers below the cheekbone, and you should be able to fit two fingers between your horse’s face and the noseband. Tip: Make sure your halter fits properly and is neither too loose nor too tight. Fasten the halter on your horse either via a clip under his jaw or a buckle on the crownpiece.If your crownpiece is only attached on one side of the halter, softly pass it behind his ears and over his neck to secure it. ![]() Guide your horse’s nose through the halter’s noseband and chin strap, and gently slide the crownpiece over his ears.With your hands on either side of the horse’s head, position the noseband so the horse’s nose will slide easily into it and raise the halter into position.Hold one side of the halter in each hand (without letting go of the lead rope), and position it under your horse’s muzzle with the crownpiece-the part that goes over his ears-in front of his head, not behind it.This will help prevent him from wandering off while you put the halter on. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |